| 3 - INSTALLING CT28 ON THE WALL BRACKET
CAUTION
Two People Required
The following task simultaneously requires moderate
two-handed lifting and the performance of fine motor
operations. To avoid possible injury or damage, this
procedure must be performed by two people.
Figure 35. Lifting the CT28 with the tilt assembly
onto the wall-mounted yoke.
•
Lift the CT28 (with the tilt arm assembly installed) in front of the
yoke installed on the wall, and insert the rotating bracket into
the yoke.
Figure 36. Inserting the bottom pivot bolt.
•
As one person holds the speaker enclosure, the second
operator should align the holes in the top and bottom of the
rotating bracket with the holes in the top and bottom of the
wall-mounted yoke and insert and thread the bottom pivot bolt,
through its washer into the aligned holes in the yoke and
bracket. DO NOT release the CT28.
Figure 37. Tightening the bottom
pivot bolt.
•
Once the bottom pivot bolt is threaded through the yoke and into
the rotating bracket, tighten it firmly using a 5 mm hex wrench.
Figure 38. Inserting the top pivot
bolt.
•
As one person continues to hold the speaker enclosure, the
second operator should then insert the top pivot bolt and thread
it through the wall-mounted yoke and into the rotating bracket .
Figure 39. Tightening the top pivot bolt.
•
Because the speaker enclosure is still free to rotate horizontally,
it should not be completely released at this point, but the mount
should safely support its weight.
Summary of Contents for Contour CT28
Page 1: ...Contour CT28 Wall Ceiling Installation...
Page 50: ......
