| 3 - DEPLOYING LCC44 ON AN ACTIVE SPEAKER TUBE & BASE
Figure 15. The Active Speaker Tube base.
•
Place the round base of the Active Speaker Tube on a flat
surface so that it rests flat and the M20 threaded nut at the
center protrudes above.
Figure 16. Attaching the 175 cm Active Speaker
Tube to its base.
•
Align and thread the M20 threaded rod at the bottom of the 175
cm Active speaker Tube into the captive M20 nut on the base .
Figure 17. Screwing the 175 cm Active Speaker tube
to its base.
•
Screw the Active Speaker Tube into the base until the outer ring
of the Speaker tube is firmly seated against the base. Check to
see that there is no movement possible of the Speaker Tube
with respect to the base plate.
Figure 18. The fully Assembled Active Speaker
Tube and Base
•
Installing the Tower Tube Mount directly on LCC44
The Tower Tube Mount can be used in two different ways, depending
on the requirements of the application. It can be installed directly to an
LCC44 or LCC84 unit when the desired coverage can be obtained with
the directivity axis of the enclosure parallel (0°) to the floor. Otherwise,
when the application requires that the LCC44/84 unit be adjustable in tilt
with respect to the floor, the Tower Tube Mount can be attached to a
Tower Rigging System rigging plate to allow different tilt angles.
To install the Tower Tube Mount directly to an LCC44 enclosure:
