| 4 - DEPLOYING LCC44 ON AN ACTIVE SPEAKER TUBE ATOP CSUB610
Figure 29. Raising the leveling feet of the
Outriggers.
•
Before installation, on each of the four Outriggers, raise the
leveling feet by screwing them in completely.
Figure 30. Removing rigging point screws from
CSUB610 for the installation of the Sub Outriggers
Figure 31. Configuring the outriggers on CSUB610
for parallel deployment of LCC44/84 units (bottom
view).
•
Using a 5 mm hex wrench, remove the two bottom rigging point
screws from one long side of the CSUB610 cabinet.
Figure 32. Aligning forward Outrigger on CSUB610
(bottom view).
•
Align the mounting hole of the longer 50° Outrigger with the
bottom rigging point nearest the front grille of the subwoofer and
thread in the M8 screw into the threaded insert of the rigging
point, making sure that the bottom bracket of the Outrigger fits
firmly around the rubber foot of the subwoofer and flush with the
bottom surface of the subwoofer cabinet.
