| 4 - DEPLOYING LCC44 ON AN ACTIVE SPEAKER TUBE ATOP CSUB610
Figure 59. Mounting LCC44 equipped with Rigging
Plates and Tower Tube Mount to Active Speaker
Tube.
•
Lower the LCC44 enclosure and allow the Active Speaker Tube
to slide into the Tower Tube Mount, making sure that it does not
catch or bind as it enters. It should stop firmly when the Tube
arrives at the top of the Mount, with the bottom of the Tower
Tube Mount coming to 2 cm above the top SpeakOn connector.
Figure 60. LCC44 with Rigging Plates and Tower
Tube Mount installed on Active Speaker Tube.
•
Physically assure the stability of the installation and that it will
not tip with mild force applied in any direction at the highest
point of the assembly.
Adjusting tilt
Though it is preferable to set the tilt angle of the enclosure before
mounting the LCC44 atop the Active Speaker Tube, it is possible to adjust
the tilt angle of the enclosure using the Tower rigging System when it is
already mounted on the Speaker Tube.
WARNING
TIPPING HAZARD – Two People Required
When adjusting the tilt angle of an LCC44 unit while
it is mounted on an Active Speaker Tube, either free-
standing or atop a subwoofer, a sudden uncontrolled
tipping of the LCC44 could render the entire assembly
unstable and cause it to fall.
To reduce the risk of injury or damage that could result
from possible toppling of loudspeaker enclosures, DO
NOT attempt this adjustment alone. One person should
maintain control of the LCC44 at all times, while a
second operator should carry out the tilt adjustment.
