| 6 - DEPLOYING LCC44 ON AN ACTIVE SPEAKER TUBE ATOP CSUB210
Important: The installer must assess the appropriate stability
and sturdiness of the deployment surface.
Restriction: Only hardware and accessories included with
the product or specified by 1 Sound should be used for its
installation.
Restriction: Do not modify or alter the loudspeaker or any
accessory. Any modification by the user or installer could render
the product or the installation unsafe.
Restriction: Do not install a loudspeaker or any accessory near
any open flame or heat source.
Products, accessories and tools required
To deploy an LCC44 enclosure as a satellite on a CSUB210 bass unit
using an Active Speaker Tube you will need the following:
•
loudspeaker enclosure
•
subwoofer enclosure
•
•
The 145 cm
Active Speaker Tube (on page 7)
, the 95 cm
or the
•
adapter kit
•
A 4 mm hex driver at least 10 cm long, preferably magnetized
•
A 4 mm Allen wrench
•
Threadlocking compound
Procedures
Installing Sub Pole Cup on CSUB210
In order to deploy an LCC44 unit in a sub/satellite configuration atop a
CSUB210 subwoofer unit, the subwoofer must first be equipped with a
Sub Pole Cup. If the SUB310 is already equipped with a Sub Pole Cup,
you can proceed to the installation of Active Speaker Tube.
Figure 109. The cover plate for the Sub Pole Cup.
•
To install the Sub Pole Cup, first use a 4 mm hex wrench to
remove the four M6×20 mm countersunk screws that hold the
cover plate in place. When these are removed, remove the
cover plate as well and put it aside.
Figure 110. Removing the cover plate for Sub Pole
Cup installation.
•
Insert the Sub Pole Cup flange into the recess in the cabinet
and seat it firmly.
Figure 111. Installing the Sub Pole Cup on CSUB210
•
Re-insert the screws that retained the plate into the four
countersunk holes in the Sub Pole Cup, and thread them into
the inserts below the cup.
