STACKED AND POLE-MOUNTED DEPLOYMENTS OF THE TOWER SYSTEM
Figure 112. Tightening the screws holding the Sub
Pole Cup.
•
Again, using the 4 mm hex wrench, tighten the four screws
firmly.
Installing Active Speaker Tube on CSUB210
In order to deploy an LCC44 unit in a sub/satellite configuration atop a
CSUB210 unit with the Sub Pole Cup installed, it is only necessary to
insert the 145 cm Active Speaker Tube into Pole Cup with the SpeakOn
connectors facing the rear of the subwoofer cabinet and assure that it is
firmly seated in the Pole Cup. For special applications, in order to meet
the requirements of the audience's listening height, the 95 cm Active
Speaker tube or the 40 cm Speaker Tube can be used in the place of the
145 cm model in this configuration.
WARNING
TIPPING HAZARD
DO NOT USE THE 145 cm ACTIVE SPEAKER TUBE
TO MOUNT AN LCC44 UNIT ATOP THE CSUB610
OR SUB310 SUBWOOFER
TO
REDUCE
THE
RISK
OF
INJURY
OR
DAMAGE THAT COULD RESULT FROM POSSIBLE
TOPPLING OF LOUDSPEAKER ENCLOSURES,
ONLY THE 95 cm ACTIVE SPEAKER TUBE
TO MOUNT ENCLOSURES IN SUB/SATELLITE
CONFIGURATIONS ATOP THE CSUB610 OR
SUB310 SUBWOOFER MODELS.
Figure 113. Installing the 145 cm Active Speaker
Tube on the CSUB210.
•
Align the Active Speaker Tube with the Sub Pole Cup installed
in the subwoofer, with the SpeakOn connectors oriented toward
the rear of the subwoofer cabinet (where the connectors are
located).
Figure 114. Active Speaker Tube installed in
CSUB210.
•
Lower the Active Speaker Tube to slide into the Sub Pole Cup,
making sure that it does not catch or bind as it enters. It should
stop firmly when the Tube arrives at the threaded M20 insert at
the bottom of the Pole Cup. The bottom SpeakOn connector of
the Speaker Tube should come to a stop at 1 cm above the top
of the Sub Pole Cup.
Installing the Tower Tube Mount directly on LCC44
The Tower Tube Mount can be used in two different ways, depending
on the requirements of the application. It can be installed directly to an
LCC44 or LCC84 unit when the desired coverage can be obtained with
the directivity axis of the enclosure parallel (0°) to the floor. Otherwise,
