| 6 - DEPLOYING LCC44 ON AN ACTIVE SPEAKER TUBE ATOP CSUB210
when the application requires that the LCC44/84 unit be adjustable in tilt
with respect to the floor, the Tower Tube Mount can be attached to a
Tower Rigging System rigging plate to allow different tilt angles.
To install the Tower Tube Mount directly to an LCC44 enclosure:
Figure 115. Threaded inserts for Tower Tube Mount
on the bottom of LCC44 or LCC84.
Figure 116. Removing screws from Tower Tube
Mount attachment points.
•
Invert the LCC44 enclosure and use a 4 mm Allen wrench or
hex driver to remove the two M6×16 mm screws from the rigging
points indicated above on the bottom side of the cabinet. Put
these aside, as they will be used to mount the Tower Tube
Mount.
•
Position the Tower Tube Mount upside-down, with the open
side up and the countersunk-drilled plate against the bottom of
the enclosure, making sure that the -3° angle of the bottom of
the enclosure is complemented by the +3° angle of the top plate
of the Tower Tube Mount, returning the long side of the Tube
Mount to form a straight line parallel to the vertical axis of the
enclosure.
Figure 117. Aligning Tower Tube Mount on LCC44
– top and side view.
•
Align the two countersunk holes in the Tower Tube Mount with
the threaded inserts in the rigging points from which the screws
were removed.
•
Carefully thread the two M6x16 mm screws previously removed
into the inserts through the holes in the Mount. A magnetized
hex driver can facilitate this.
Important: For permanent or semi-permanent installation of the
Tower Tube Mount on the LCC44 enclosure, the use of medium-
strength threadlocking compound is recommended on all user-
installed screws.
