STACKED AND POLE-MOUNTED DEPLOYMENTS OF THE TOWER SYSTEM
Figure 98. Coupling the rigging plates between
LCC44 and Tower Tube Mount.
•
When these are perfectly aligned, take one of the M10×100 ball-
lock pins supplied with the rigging plates and press the lock
release on the rear of the pin to allow it to pass into the hole.
Insert it into the holes, pushing it completely through all four
aligned holes until the ball-lock emerges from the far side. When
it emerges, allow the lock to engage and assure that the pin
cannot be removed without again pressing the release. When
the front of the plates are coupled, it should be possible to freely
tilt the upper plate (with the Tube Mount installed) with respect
to the LCC44. This done, it is possible to fix the tilt angle of the
speaker enclosure.
Setting tilt angle of LCC44 with Tower Tube Mount and
Rigging Plates
There are two configurations possible for using the Tower Tube Mount
with the Tower Rigging System rigging plate: one that allows the coupled
satellite enclosure to be tilted -3°, 0° or +3° with respect to the floor, and
another that allows only downward angles of -3°, -6° and -9°.
•
With the two plates coupled by the forward ball-lock pin, tilt the
upper plate (with the tower tube mount installed) so as to align
the rear holes of the two plates that correspond to the desired
tilt angle.
Figure 99. Setting tilt angle with the Tower Tube
Mount configured for -3°, 0° and +3°.
Figure 100. Setting tilt angle with the Tower Tube
Mount configured for -3°, -6° and -9°.
Figure 101. Fixing tilt angle of Tower Rigging
System and Tower Tube Mount (-3° shown)
•
When the required holes are perfectly aligned, take the other
M10×100 ball-lock pin supplied with the rigging plates and
press the lock-release button on the rear of the pin to allow
it to pass into the hole. Insert it into the holes, pushing it
completely through all four aligned holes until the ball-lock
emerges from the far side. When it emerges, release the button
to allow the lock to engage and assure that the pin cannot be
removed without again pressing the release. The enclosure is
now coupled at the proper angle to the mounting assembly and
ready to mount on an Active Speaker Tube.
Mounting LCC44 on Active Speaker Tube using the Tower
Rigging System
Once the Tower Tube Mount has been correctly assembled with a
Rigging Plate, coupled with an LCC44 enclosure likewise equipped with
a rigging plate and the tilt angle has been fixed, the enclosure can then be
very simply mounted on an Active Speaker Tube, either atop a CSUB610
or SUB310 subwoofer in a sub/satellite configuration, or independently
atop an Active Speaker Tube with base.
