Mute
Touch to mute the
output.
3 & 4
If 3&4 Mode is Stereo,
controls OUTS 3 & 4.
If 3&4 Mode is Mono,
controls OUT 3.
4
Controls the level
sent to OUT 4.
1&2
Controls the level
sent to OUT 1 & 2.
B
Push to configure output
options like those in table.
PHONES
Control the level sent
to the PHONES out.
ADJUST OUTPUT LEVELS AND SET OUTPUT OPTIONS
Push MAIN to control the output levels.
Push MAIN then B to configure the output options. The table below is a partial list of options.
Copyright 2023 by 1010music LLC
Page 3
Output
Option
Description
Values
Phones Srce
The signal to send to the PHONES output.
CUE, Main
USB Rcv
Which tracks will receive the USB Audio Stream.
None, 1&2 thru 11&12
3&4 Mode
Choose how outputs 3 and 4 are used.
Stereo, Mono
3&4 Send
FX1 & FX2 Send
Control whether the corresponding signal levels are sent
pre- or post-fader.
Pre-Fader, Post-
Fader
Compressor
Is the compressor applied to the MAIN bus.
On, Off
See the User Manual for the full list options
MANAGE PROJECTS
The bluebox stores all of your settings and the collection of WAV recordings as a project on the
microSD card. Recorded WAV files will stay with your project, but you must save the project if
you want other changes to persist.
To Save the Current Project:
1. Push PROJ.
2. Touch Save.
To Manage Project Settings:
1. Push PROJ, then push B.
2. Use a top knob to select a parameter and a
bottom knob to change it’s value.
3. Touch the tabs across the bottom to access
MIDI and CV settings.
To Manage Projects:
1. Push PROJ.
2. Touch File.
3. Touch the file option you want: New,
SaveAs Template, or Rename.
To Load a Different Project:
1. Push PROJ.
2. Turn a knob to select a project.
3. Touch Load. Note: Load is disabled for the
currently loaded project.
