3/9/17 3:20 PM
Copyright 1010 Music 2017
fxbox Quick Start Guide
Before You Start
A microSD card must be inserted into
fxbox before you can get started.
Fxbox takes audio input from IN1 and
IN2, processes the configured effects,
and sends the result to OUT1 and
OUT2. All settings are stored on the
microSD card.
Apply Effects
When fxbox starts up, the
Touch Screen
displays the
Main
screen with the effects
grid. Activate an effect by doing one of the
following:
•
Touch a cell on the
Touch Screen
to
momentarily enable that effect.
•
Trigger the effect via CV signal by
plugging a gate signal into the
CV
Trigger
jack that maps to the effect
in the grid.
•
Set the effect to be always on by setting the
Trigger Mode
property for the effect to
ON
by
following the steps below. (Not all effects have a trigger property.)
Edit the Parameters of an Effect
1.
Touch the cell of the effect in the grid on the
Main
screen.
2.
Push the
Info
button.
You will see parameters specific to that effect, such as
Cutoff
and
Delay Time
.
3.
Adjust a parameter by turning the
Control Knob
next to it.
4.
Alternatively, touch and drag in the middle of the
Touch Screen
to control
the first two parameters using X/Y control. Move your finger left and right to
control the first parameter, up and down to control the second parameter.
Note:
•
The signal processing chain applies the effects in the same order in which you read a book: Left to right,
then top to bottom.
Select a Preset
1.
From the
Main
screen, you can cycle through the list of presets by
touching the
–
and
+
buttons on either side of the preset name
(
02BadTapeEcho
in the
Main
Screen example shown above right).
2.
On the
Main
screen, touch the preset name at the top of the grid (or the
space above it) to display the
Presets
screen.
3.
Select a
Preset
by scrolling through the list with any of the
Control
Knobs
, and then touching
Load
in the top right corner of the
Touch
Screen
.
Note:
•
All changes you make to the sound are automatically remembered and
written to the preset. There is no option to “Discard Changes” or “Save Preset”.
Mute Effects
1.
While on the
Main
screen, push the
Home
button to enter mute editing mode. The grid cells will be
green.
2.
Touch a cell to mute that effect. The cell will turn red. Touch it again to remove the mute.
3.
Push the Home button to leave mute editing mode. A red bar appears over the names of muted effects.
Main
Screen
Presets
Screen
