AE Wireless Temperature Sensor
Version 1.0.0 - 4/22/2021
Product Overview
Items Included:
1.
1 - AE Wireless charging station (WCS)
2.
4 - AE Wireless Temperature Sensors (WTS)
3.
1 - AC Adapter
4.
1 - USB-A to USB-C charging cable.
The AE Wireless Temperature Sensor contains an infrared temperature sensor which is used to measure
and record the temperature of a surface. A User is able to place the device against a desired surface and
continuously monitor the temperature of the location. The sensor is able to record and wirelessly transmit
the temperature data to a mobile device.
Notes
In order for the User to access the information transmitted by the Wireless Temperature Sensor (WTS),
there is an accompanying AE mobile application that must be downloaded and used on a mobile device. The
mobile application allows the user to interface with the WTF and access WTS’s internal information
wirelessly.
Operational Modes
The AE Wireless Temperature Sensor (WTS) contains two operational modes, and one sleep mode. The
first operational mode is charging, where the device is not performing temperature measurements and is
focused on charging the internal battery. While the WTS is charging, it will limit wirelessly accessible data to
the state of charge of the battery and charge status. This is reflected in the mobile application where the
user is able to see the status of the battery while temperature information is removed from view.
The second mode is normal operation mode. In this mode the WTS discharges from the internal
battery and performs periodic temperature readings from the surface directly in front of the infrared
temperature sensor. The data is collected and wirelessly transmitted to a mobile device. During this
operational mode the User is able to view within a mobile application, battery status information and
periodic temperature information.
The last operational mode is sleep mode. In the event the internal battery is discharged to a critical
level. The sensor will enter a sleep mode and will be unable to be detected or connected to wirelessly. It is
recommended when the device enters this sleep state that the User places the device on the charger
within 24 hours, in order to recharge the sensor’s internal battery.
