31
8
Unit-HiHat Pedal
CALIB
calibrates the hihat. If a dash is shown, the hihat is not
connected. A closed hihat symbol will blink if the hihat is not
calibrated yet, otherwise press CALIB to start the calibration. Now
loosen the hihat and let it rest on the hihat receiver. Press CALIB to
store the closed position, now an open hihat symbol will blink. Open
the hihat to the position where the sound should just reach
completely open and press CALIB once more to store the open
position.
If the calibration is ok, Done will be displayed, otherwise NoChg
appears indicating that no settings have been changed. This might
be because the range between open and closed is too small. Finally
fix it at a (possibly higher) open position which suits ones playing
style.
MIDI
selects between continuous controller 1 or 4. The CC value
range can be set from 0 when open to 127 when closed (arrow
down) or from 0 when closed to 127 when open (arrow up).
Normally MIDI pedal data is only sent just before a note on,
selections with a ! indicate that pedal changes are sent continuously.
Pedal down transmits control change and note on, the corresponding
note off is send when the pedal moves up again. A short time
between down and up results in a foot splash, a longer time results
in a foot chick.
LEVEL
shows the pedal trigger level in dBs. It is also shown on the
UNIT-TRIG page when the hihat channel is selected.
SENS
sets the sensi-6 dB. Adjust it so only a firm foot down
gives full trig level (0 dB).
CURVE
has 9 settings (see description on UNIT-TRIG page).