25
EN
USING THE DEVICE
INSTALLING
• It is the best to mount the dash camera in the upper edge of the car’s front windshield,
beneath the rear-view mirror or next to it.
• Clean the mounting area carefully and ensure the windshield is not damp.
• Ensure there is unobstructed view to the camera and that the vision of the driver is not
blocked.
• Ensure that the selected mounting area is suitable for the length of the USB charging
cable
• Remove the protective film of the fastening tape of the camera holder and fasten the
holder by pressing it firmly on the windshield
• Insert an empty microSD card in the dedicated slot.
• Connect the camera carefully to the magnetic connector of the camera holder and
connect the USB charging cable. The USB charging cable is long enough so that in most
passenger cars it can be mounted along the edge of the windshield to the charging
socket.
• The camera switches on automatically when the power is turned on.
PLEASE NOTE!
• The device is fastened with a very strong acrylic foam tape, which resists changing
conditions and UV radiation. It is not recommended to remove it and to re-fasten
it.However, if it is necessary to remove the camera holder and to re-fasten it, a new tape
strip should be used.
• The easiest way to remove the camera holder is to remove first the camera and thereat
to grasp firmly from the edges from the edges of the holder, as close as possible to the
windshield.by turning the holder clockwise or anti-clockwise, the tape should release.As
the tape is characterised by strong tensile strength, it is difficult to remove it by pulling.
Do not use a screwdriver or any other tool for removing ,as this may damage the holder or
windshield.
• In some car models power supply to the charging socket is not interrupted when the
engine is switched off. In this case disconnect the charger from the charging socket, to
avoid draining the car’s battery.
