54
2GIG EDGE User Guide
Smart Home Settings
Refer to the 2GIG EDGE Smart Home manual .
Bypass Sensors
You can manually bypass a sensor using the
Bypass
Sensors
button(
) in the
System Settings
menu .
When you need to bypass one or more perimeter or
interior sensors, it is most common to manually bypass
the sensor . There is also an alternate method for
bypassing a sensor called
Force Bypassing.
See
, pg . 23 .
NOTE:
To use this feature, you must know the
Master User Code .
Manually Bypassing a Sensor
When manually bypassing a sensor, tap the
Bypass
Sensors
option in the
System Settings
menu to add
the desired sensors to the
Bypassed Sensors
list .
WARNING!!
A bypassed burglary protection
sensor does NOT provide security protection
when the system is armed .
1 .
Enable the
Bypass
option(s) to bypass selected
sensors .
2 .
Press the back button (
) .
The system is now ready to arm with selected sensors
bypassed . The system bypasses the devices and its
status changes to
Ready To Arm (BYPASS)
.
After the system is disarmed, bypassed sensors are
automatically removed from the system’s
Bypassed
Sensors
list, unless the
Auto Bypass for Manual
Bypass
feature is enabled .
NOTE:
Consult your installer to determine if
the Auto Bypass for Manual Bypass feature is
enabled .
Bypass Sensors
Ready to Arm (Bypass)
Removing Sensors from Bypassed Sensors List
After the system is disarmed, bypassed sensors are
automatically removed from the system’s
Bypassed
Sensors
list, unless the
Auto Bypass for Manual
Bypass
feature is enabled . If you decide you want to
remove a sensor from the
Bypassed Sensors
list before
you arm the system, use the steps detailed here .
To remove a sensor from the
Bypassed Sensors
list:
1 .
At the System Settings screen, tap
Bypass
Sensors
.
2 .
Move the slide control to the left for the desired
sensor . This removes the sensor from the
system’s
Bypass Sensors
list .
3 .
Tap
when finished.
Remove Bypass Sensors
