25
Copyright © 2021 Nortek Security & Control LLC
Use the Quick Exit Button
The
Quick Exit
button gives users the ability to start an
Exit Delay
countdown while the system is armed . This
gives users the ability to leave the premises through an
Exit/Entry
door, instead of having to disarm and then
rearm the system .
When the
Allow Quick Exit
setting is enabled, the
QUICK
EXIT
button appears on the
System Armed (STAY)
screen .
NOTE:
Consult your installer to determine if the
Allow Quick Exit setting is enabled or disabled on
the system .
To use the
QUICK EXIT
button:
1 .
Arm the system in Stay Mode . See
, pg . 21 .
2 .
At the
System Armed (STAY)
screen, tap
QUICK
EXIT
.
This starts the
Exit Delay
countdown to give you time to
exit through an
Exit/Entry
door without having to re-arm
the system . At the end of the countdown, the system
rearms itself in the Armed Stay mode .
System Armed—Quick Exit Button
In the Event of an Exit Error
If you arm the system and an Exit/Entry door is left in
a violated state or condition at the time the Exit Delay
countdown expires (for example, the door you exit
from doesn’t close behind you), the 2GIG EDGE Panel
sounds the local alarm and the Entry Delay countdown
begins .
If you do not disarm the system when the Entry Delay
countdown begins, the system automatically begins the
alarm transmission sequence .
The panel also transmits an Exit Error report to the
Central Station and displays an Exit Error message on
the panel screen, as shown below .
Alarm Transmission & Exit Error Sequence
