4.
Set the BUS detector ID number (1–32) using the detector's DIP switches.
NOTE:
Do not repeat the same ID twice on the same BUS zone expander.
5.
Wire each detector's BUS terminals to the relevant BUS zone expander's terminal labeled TO DEVICE.
NOTE:
For maximum operation stability, it is best NOT to exceed a total of 300 meters (1000 feet) of wiring from the BUS zone
expander to the 2GIG Vario system panel, and 300 meters (1000 feet) of wiring from the BUS zone expander to the last BUS
detector.
2GIG Vario Quick Install Guide
Copyright © 2016 Nortek Security & Control LLC
9