background image

 

 

The 

RF-OPTIMA

 surface-mounted radio thermostat has been developed to be able to switch electric 

and conventional heating systems on and off using a set temperature and time. 

 

 

 
 

 

Large display can be clearly read with the background lighting. 

 

Easy to fit thermostat and receiver. 

 

Five buttons make it easy to use. 

 

70 switching programmes per week (10 individual programmes per day by time and temperature). 

 

The display shows the set temperature as well as the measured temperature, time and programme selection. 

 

Temperature display in degrees Celsius. 

 

Battery status display. 

 

Programming or Manuel function  

 

The thermostat is supplied with a wall-fixing frame, base and a very compact receiver (flush-mounted or surface-mounted). 

 

 
 

Thermostat operating voltage: 

 

2 x AA 1.5 V, alkaline batteries. 

Backup storage:   

 

 

EEPROM 

Receiver operating voltage:  

 

230 VAC, 50/60 Hz 

Maximum voltage / (ohmic) load: 

 

250 VAC/10 A. 

Maximum voltage / (inductive) load:   

250 VAC/3 A. 

Frequency: 

 

 

 

868 MHz. 

Channel selection:  

 

 

By programming the thermostat and the receiver. 

Switching options:  

 

 

10 programmes per day, irrespective of the day. 

Receiver switch contacts: 

 

 

NO and NC. 

Temperature settings: 

 

 

0°C ~ 60°C, 0.5°C increments. 

Accuracy: 

 

 

 

+/- 0.5°C (+/- 1°F). 

Thermostat dimensions: 

 

 

Surface mounted, 134 mm x 94 mm x 28 mm. 

Display dimensions: 

 

 

69 x 49 mm. 

Receiver dimensions: 

 

 

Flush-mounted/surface mounted, 86 mm x 86 mm x 23 mm. 

Colour:   

 

 

 

White 

IP protection rating: 

 

 

20. 

Certification: 

 

 

 

CE. 

 

 
 

 

Always switch off the voltage when carrying out installation work. 

 

Read the operating instructions fully before installing the thermostat and the receiver. 

 

The thermostat must be installed by a professional. 

 

Installation must be carried out in accordance with (N)EN standards (within the EU). 

 

The thermostat has an internal glass fuse to protect the electronics. If the thermostat is not working, check the cable and the fuse. 
Replace the defective fuse with a correct value replacement fuse. 

 

Only use the thermostat as outlined in the operating instructions. 

 

Always use alkaline batteries (e.g. Duracell) and charged batteries in the thermostat battery holder. 

 
 
 

 

RF-OPTIMA THERMOSTAT 

 

        

Options for and advantages of the RF-OPTIMA thermostat: 

 

       

Technical data: 

 

       

Advice 

Summary of Contents for RF-OPTIMA

Page 1: ...mming the thermostat and the receiver Switching options 10 programmes per day irrespective of the day Receiver switch contacts NO and NC Temperature settings 0 C 60 C 0 5 C increments Accuracy 0 5 C 1 F Thermostat dimensions Surface mounted 134 mm x 94 mm x 28 mm Display dimensions 69 x 49 mm Receiver dimensions Flush mounted surface mounted 86 mm x 86 mm x 23 mm Colour White IP protection rating ...

Page 2: ...MOSTAT Location coding Channel selection A Calibrating the thermostat temperature Setting the time and day on the thermostat C D E F G To set the time and day with the following steps Press and hold the SET button E for around 3 seconds The minutes display 01 top left in the display flashes Change this value using the F and G buttons Press the SET button E The hour display 02 top left in the displ...

Page 3: ... the PRG D button the temperature flashes B change the value with the F and G buttons The temperature can be set with steps of 0 5 C Press the PRG D button the PRG program event flashes C You be able to setup the next event The thermostat uses the setting from event PRG 0 till PRG 1 The setting from PRG 1 goes till event PRG 2 from PRG 2 till PRG 3 from PRG 3 till PRG 4 from PRG 4 till PRG 5 from ...

Page 4: ...he thermostat and the receiver have sensitive electronics The RF OPTIMA cannot tolerate moisture and extreme heat ensure that the thermostat and the receiver are suitably protected Miscellaneous We hope you enjoy using the RF OPTIMA thermostat If you have any questions please contact Copyright LVDS 4 Miscellaneous Assembling and connecting the receiver COM Common contact NO Normally open contact N...

Reviews: