16
are feeling cold or hot, wait a while before taking a measure-
ment.
• If the monitor is stored at very low temperature (near freez-
ing), have it placed at a warm location for at least one hour
before using it.
Wait 5 minutes before taking the next measurement.
1. Press the User-Switching key to select memory zone 1, mem-
ory zone 2 or guest mode. After a memory zone is selected,
press the ON/OFF/START key to reset the monitor so it can
start measurement in the chosen memory zone.
2. Press the ON/OFF/START key. All digits will light up, check-
ing the display functions. The checking procedure will be
completed in 2 seconds.
3. After all symbols appear, the display will show a blinking “0”.
The monitor is ready to measure and will automatically inflate
the cuff slowly to start measurement.
4. Bluetooth® will automatically be activated on the device,
please see
Data transfer via Bluetooth®
. you can also start
measurement directly by pressing the ON/OFF/START key
again, but the current measured reading (Systolic, Diastolic
and Pulse) will not automatically be transferred to the App.
5. When the measurement is completed, the cuff will exhaust
the pressure inside. Systolic pressure, diastolic pressure and
pulse will be shown simultaneously on the LCD screen. The
measurement is then automatically stored into the pre-desig-
nated memory zone.
6. In order to enhance the probability of pulse arrhythmia de-
tection by the PARR technology, measurement repetitions
are recommended.
This monitor will re-inflate automatically to approximately 220
mmHg if the system detects that your body needs more pres-
sure to measure your blood pressure.
Note:
1. This monitor automatically switches off approximately 1 min-
ute after last key operation.
2. To interrupt the measurement, simply press the ON/OFF/
START key; the cuff will deflate immediately.
3. During the measurement, do not talk or move your arm or
hand muscles.
