Table of Contents
Tail surface installation..…………………01-06 Tail plane……………………………………………01-05
Servo tray………………………..………07-10 Tail servo mounting…………………………………07-11
Receiver mounting………………………19-20 battery mounting……………………………………32-36
Servo and battery mounting…………….24-34
Tail control wire setup………………………………13-17
Motor mounting…………………………21-29
Spinner and prop…………………………26-29 Wing mount.…………………………………………48-49
Ailerons control install……...……………38-47 C.G. adjust……………………………………………….51
01
01
First install the Stab. In fuse. And mark the edge with
marking tape, then use hobby knife made a line small
hole on the cover surface of cover for ensure when
you glue Stab with Fuse was good.
02
Find Elevator control horn hole on the Elev. And trim
off covering film as show.
03
Install the Elevator In the fuse. As the show.
Notice: the control horn hole must same side as the
control wire out let.
