4
孔位说明
7
寸人脸门禁一体机固定孔位
10
寸人脸门禁一体机固定孔位
7
寸人脸核验终端固定孔位
4
Bracket Introduction
When the digital detection module is used in combination with a face recognition
access control terminal or face recognition terminal, a bracket (purchased
separately) is required for installation. The bracket is delivered with four M4x11
screws and two M4 wing nuts.
3
Device Installation
3.1
Device Wiring
1
Cable layout description
Before installing the digital detection module, plan the layout of the power cable.
For the diameter selection for the extension power cable, see the table below.
Hole description
Hole for fixing a 7-inch face recognition
access control terminal
Hole for fixing a 10-inch face
recognition access control terminal
Hole for fixing a 7-inch face recognition
terminal
