!! Preliminary version of user guide v1.8 !!
!! Preliminary version of user guide v1.8 !!
73
-
Random and limit ; then SIM 1
– SIM cards will be switched at random time and by credit.
In case that all SIM card have no credit (counters are empty), the SIM card in position one
will be activated
Last searched SIM –
(SIM1 – SIM8) : After start the gateway is automatically checking all SIM
position for SIM card. With this parameters you can limit holders which will be tested. SIM cards
which were not tested have in diagnostic window status “(undef)”.
Disconnect call
– Setting for forced disconnection of proceeding calls
- SIM limit exceeded
– The call will be disconnected immediately when the SIM card’s call
limit is exceeded.
- Switch to another SIM card
- The call will be disconnected immediately when the SIM
card will be out of time of use.
Day of delete statistics in group
- x. day in month when the statistics of the GSM group will be
deleted.
No ALERTING before CONNECT –
by activation this parameter you remove ALERTING message
from messages sequence of building outgoing calls to GSM.
Delay for send CONNECT (s)
– Delay for send ISDN message CONNECT to ISDN PRI interface
(in case that PRIGW is building call from ISDN to GSM).
Timeout for send ALERTING(s)
– Timeout for send the ISDN message ALERTING to ISDN PRI
interface (in case that PRIGW is building call from ISDN to GSM). 0= switched off
Timeout for SMS at no answer (sec) –
Minimum length of ringing outgoing call. In case that this
time will be longer that this parameter and call will be not connected, gateway will send to called
party number SMS message with defined text. For right function of this feature you have to have
called party number in defined format – national or international where is “00: instead of “+”.
SIM settings
– By this parameter you can change assignment of times from parameters “Time of
use”
- SIM 5-8 is SIM4
- Time limitation of SIM cards 5-8 will be same as SIM cards in position 4.
- SIM 5-8 is SIM1-4
– first time interval in bookmarks SIM1-SIM4 will be used for SIM cards
in positions 1 – 4. Second interval (2
nd
interval) in these bookmarks will be used for SIM
cards in position 5 -8.
Allow tone detector –
Enables ring tone detectors on GSM boards.
‘Minute’ parameter
– By this parameter you can change counting of outgoing calls.
- Count of minutes
– Gateway will counter time of outgoing calls. You can set maximum
of minutes by parameter Number of called minutes
- Count of calls
– Gateway will counter number of outgoing calls. You can set maximum
of outgoing call by parameter Number of called minutes.
Bookmarks SIM1- SIM4-8
– In these bookmarks is necessary right set-up parameters of each SIM
card..
Roaming enabled for network –
Whole or part (mask character is “x”) of international ID of
GSM network (MCC+MNC) which is enabled for roaming. Please leave it free for cases that you
don’t want to enable roaming.
