15
Intelligent Incoming Call Routing Control
From the viewpoint of the user, this function can work completely automatically but
moreover it is possible to complete the Intelligent Incoming Call Routing Table during any
call by special command:
Command for Intelligent Incoming Call Routing fill-up:
Example:
(route this subscriber to extension 234)
Extension number entering, or
for command
cancelling.
Zero instead of extension number - enables dialing
to calling party
Extension number, up to 8 digits
Empty - erases a record with this CLIP, if found.
Password entering, after it GSM gateway will send
confirmation signal. Or
for command cancelling.
Password for fill-up into table
If the GSM gateway executes this command, it will send a confirmation signal as well as
sending an error signal in the following events:
•
Routing is disabled (error will be sent as soon as password is entered).
•
Whole table is “locked” – only programming by PC can modify it.
•
CLIP is unknown (error will be sent as soon as password is entered).
•
CLIP is already stored in locked part of table; this entry has a priority and cannot be modified.
Notes:
•
If 0 (zero) is entered instead of extension number, GSM gateway enables calling party to dial any
number. This is a way, how to enable this possibility only to selected persons. Another incoming calls
are connected to pre-selected extensions or refused (dependent on a GSM gateway configuration).
•
Only unlocked part of table can be filled-up by this command. Once it is full, new ones will
overwrite oldest entries. Size of available unlocked part is from 0 to 99 entries, depending on
size of locked part. Only programming by PC can modify the size of locked part and its content.
•
This command is ignored until a connection is established.
•
In the case of outgoing calls, the called subscriber number is usually incomplete (without
international prefix). In case of incoming call, CLIP is complete and international prefix starts with “+”.
To make these numbers comparable, incomplete number is completed automatically within writing
to the table, this way:
o
If called number begins with “00” (or with different international prefix defined by parameter 115),
it is removed and only “+” character is added to its beginning.
o
If called number begins with one “0” (or with different long distance code defined by
parameter 117), it is removed and “+” and your country code is added to its beginning.
o
In other cases, “+” and your country code is added to its beginning.
•
While programming by PC, an incomplete CLIP can be entered – e.g. bare international
prefix. In this example, incoming calls from each country will be routed to the person who is
proficient in the appropriate language etc.
•
While programming by PC, each CLIP must begin with country code.
Summary of Contents for ATEUS 501101E
Page 2: ......
Page 35: ...33 5 4 11 Remote Supervision Establishing Flow Chart ...
Page 56: ......
Page 57: ... 2002 2N TELEKOMUNIKACE a s Prague DR 972 v 1 33 ...
