2N TELEKOMUNIKACE a.s., www.2n.cz
118/152
6.3 List of Terminal AT Commands
By default, all these commands start with AT. (Note: Some of the AT commands listed
below may not be available in the current firmware versions.)
Basic AT Commands
The following command list is intended for all GSM gateways from
that are based
2N
on the same SW architecture. Some of the AT commands may be inaccessible for the
BRI gateways.
A/ – repeat last command (without AT)
I3 – copyright & firmware
I4 – serial number
&FRES – factory defaults & reset
&V – view active parameters (system)
&VI – view active parameters (isdn)
&V0 – view active parameters (common)
&V# – view active parameters (modules 1..2)
&VB - Overview of module assignment to groups
format: B#=grpout0, grpin0
# is the module number
grpout, grpin - outgoing and incoming groups of module
&V9 – view active parameters (inc. groups)
&VALL – view all group parameters
&VE – Overview of VOIP parameters
&P – view pseudo params
&N# – view network params (net 1..8)
&NALL – view all network params
&A – view autorouting table <SPACE...continue>
&R – view lcr–routing table <SPACE...continue>
&T – view bris + modules totals
&TMOD – view all modules totals
&G##=atcommand – send at command to module 0..1 (ended by OK from gsm)
&G##=xtcommand – send at command to module 0..1 (ended by <CR> from
user)
&G##=cmd – cmd for module 0..1 (RESET,BLOCK,OFF,DOWN,ON), (ATBAUD)
&GALL=cmd – cmd for module 0..1 (RESET,BLOCK,OFF,DOWN,ON)
&S – view aux, bris, modules status
