2N TELEKOMUNIKACE a.s., www.2n.cz
69/152
Tones generated to VoIP
Ring tone to VoIP – enable generation of a user ring tone or transfer of the real
ring tone from the GSM/UMTS networks.
ISDN Parameters
Use this window to set the BRI ISDN port parameters. The appearance and count of
the parameters may be different in
and
due to
2N BRI Lite
®
2N BRI Enterprise
®
different counts of ISDN BRI ports.
BRI mode selection
Mode – set the BRI1 and BRI2 (for
only) ports.
2N BRI Enterprise
®
BRI1 and BRI2
TEI Address – set a fixed TEI address for connection of port(s) in the Point–to–
Point mode.
MTP – activate assignment of the dynamic TEI address (Point–to–Multipoint
mode).
Progress indicator value – set the value for each progress element for call setup.
Please respect the PBX and PSTN settings to avoid wrong evaluation of messages
sent by the BRI gateway and, subsequently, call setup errors. Refer to the table for the
decimal numbers to be assigned to the progress messages.
Number Meaning
OFF
Progress element is not sent in the message
1
Connection is not end–to–end ISDN, following progress messages will be sent in the
speech band
2
Call destination address is not ISDN
3
Call initiator address is not ISDN
4
Call is returning to ISDN
