2N TELEKOMUNIKACE a.s., www.2n.cz
74/152
DTMF settings
Minimum delay between two identical DTMF characters [s/100] received.
Tone detector settings
The GSM gateway can automatically detect user defined tones transmitted by GSM
/UMTS for setting up outgoing calls to the GSM/UMTS networks. In general, they are
tones of a transferred number. For the purpose of such detection, the GSM gateway
automatically terminates the call and tries to set it up via another available outgoing
group (if defined in the LCR).
Frequency 1;2;3;4 – define the frequencies for the tone to be detected.
Sequence list – set the sequence of the tones to be detected.
Voice message detector settings
Minimum percent to match – set the match percentage range in which the voice
message is detected as identical with one of the voice messages recorded in the
section under index 30 - 37. The
Gateway control / Voice messages
recommended value is 70-90%.
Cinterion Module Settings
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction
Enable connection tone – enable the connection tone.
End call with SHUP – end calls with the SHUP command.
Enable HR codec – enable the Half Rate codec for the GSM network.
Enable AMR codec – enable the Adaptive Multi-Rate codec for the GSM network.
Wavecom Module Settings
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction
GSM-band selection – select the GSM frequencies for the mobile network.
Echo cancelling – enable/disable echo cancelling for the module.
Enable HR codec – enable the Half Rate codec for the GSM network.
Enable AMR codec – enable the Adaptive Multi-Rate codec for the GSM network.
Telit Module Settings
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction