2N TELEKOMUNIKACE a.s., www.2n.cz
88/152
Weekend usage – enable/disable a row on weekends.
Call duration limit – set the maximum duration (minutes) for an outgoing call to
the GSM/UMTS network.
Groups – define the outgoing GSM groups or interface via which outgoing calls
will be routed from
gateway. If the defined interface is inactive or the
2N BRI
®
outgoing GSM group tariff is exhausted, the next row will be applied.
GSM groups 1-2 – outgoing GSM groups. Set the tariff to be used. Refer to
the GSM outgoing groups subsection for details.
BRI1 (P) – ISDN BRI1 interface. Refer to the
subsection for
ISDN parameters
details.
BRI2 (E) – ISDN BRI2 interface. Refer to the
subsection
ISDN parameters
for details.
VoIP (V) – VoIP interface. Refer to the
subsection for
VoIP parameters
details.
Tariffs – select the tariff group (free minute counter) to be used for the outgoing
call. Refer to the GSM outgoing groups subsection for details.
Ignore tone detection in last group – having detected a user defined tone (refer
to GSM basic settings), the GSM gateway automatically terminates the call and
seeks for another call setup way. If this parameter is activated, the GSM gateway
ignores the tone detection results and sets up a call when this is the only
possible call establishing way.
Note
If you use tariff routing, set the tariffs properly in the GSM outgoing
groups subsection.
The maximum count of LCR table records is 64.
The rules are applied to calls sequentially, starting from the first rule. If
all the set rules are met in a row, the call is routed according to the row.
Call routing from BRI1/BRI1, BRI2/BRI2 and VoIP/VoIP is not supported.
Such calls will be rejected by
gateway.
2N BRI
®
CLIP Routing Table + CallBack
Use the table to set a fixed CLIP assignment of incoming CLIPs from GSM to the
numbers of extensions to which incoming calls are routed automatically. Also, set the
CLIP list in the GSM network for which CallBack is enabled.
GSM number (CLIP) – user Id in GSM/UMTS.
Used service
Autodial – enable/disable CLIP routing for the selected CLIP.
Reject call – reject call for the selected CLIP.