2N TELEKOMUNIKACE a.s., www.2n.cz
127/377
1.
2.
Safety
The bus is electrically isolated from the telephone line circuits according
to the EN60950 requirements and its low voltage cannot cause any
electrical accident.
Mode Switch
Set the camera module connection mode with a 10-position switch 0–9:
0 – the camera module works within the
system (connected to the CU
2N Lift8
®
/splitter via a 2-wire bus);
1 – the camera module works autonomously (see below for details);
2–9 – no setting (the red ERR LED is flashing).
IP Camera Connection
There are two IP camera connection options.
Connect the IP camera directly to the camera module.
Connect the camera module to the LAN if the IP camera is installed in the LAN.
If the camera module is connected to the Lift8 system, use the Service Tool for
configuration (refer to Subs. 5.3 – Service Tool – Use for more details).
Refer to the Autonomous Camera Module Connection Subs. for more setting details.
Summary of Contents for Lift8
