2N TELEKOMUNIKACE a.s., www.2n.cz
132/377
Caution
You are recommended to format the microSD card before inserting it in
the camera module (FAT32).
You are recommended to connect the camera module to a backup
power supply to avoid recording errors at power outage. Connect the IP
camera to the backup power supply too.
Camera Module Settings ( network.cfg)
Parameter
name
Default
value
Note
IP address
10.0.0.254
Camera module IP address
Gateway
0.0.0.0
Gateway IP address
DNS
0.0.0.0
DNS server IP address
Netmask
255.0.0.0
Network mask
DHCP
camera ip
address
0.0.0.0
0.0.0.0 = disabled
Ip address = DHCP server enabled on camera module. Used only if
the IP camera is directly connected with the camera module.
Caution
Set Camera IP address to enable the DHCP server and assign the
selected address to the IP camera. Make sure that the Retrieve IP
address from DHCP server option is enabled for the camera.
Refer to network.cfg for more setting details.
Having set the network parameters, you can open the Internet browser
to go on configuring via the web interface (see the Web Interface
below).
Summary of Contents for Lift8
