2N TELEKOMUNIKACE a.s., www.2n.cz
150/377
3.1 Lift8 Programming
The advantage of the
(hereinafter referred to as
) system is that it is
2N Lift8
®
L8
programmed via the
where all the parameters are stored. Hence, you do not have
CU
to reconfigure anything to replace an Audio Unit and you can program just one
in
CU
multiple lift systems, for example. The memory is independent of the
power.
CU
Before You Start
Fill in all the values to be changed in the prepared form with a clear table of
basic functions.
If the
is not brand new, make sure that you have the correct servicing
L8
password, and if you are not completely sure of your
configuration, execute
L8
full initialisation (Warning: The servicing password is also initialised!).
L8 can be programmed in 3 ways: remotely via a telephone (telephone number),
using the machine room Audio Unit and/or using the service tool program
(connection via USB/IP address).
Make sure that your telephone supports tone dialling (key phones may cause
problems in some PBXs).
Caution
Warning: The servicing password is also initialised!
Access to Programming Mode
You can enter the programming mode during an incoming call (calling the
number)
L8
or using the machine room Audio Unit (press
for over 2 seconds).
Use the voice menu (press 9 for administration and 1 for access to the programming).
Upon request, enter the servicing password as follows:
(do not
servicing password
forget to put an asterisk after the password).
If the password is correct,
announces:
L8
“You have entered the programming menu,
select a parameter”.
The factory password is 12345 but you are recommended to enter a different
password to protect your device against unauthorised persons.
Summary of Contents for Lift8
