2N TELEKOMUNIKACE a.s., www.2n.cz
183/377
1.
2.
3.
4.
5.
4.2 Control Centre Instructions
ALARM Call
Press the ALARM button on any audio unit to make
call the control
2N
®
Lift8
centre (refer to Automatic Dialling for details).
A received call is either confirmed as configured (parameters 111–116 >
Confirmation mode for memory 1–6 ALARM call – set 1). By default, confirmation
of DTMF 1 is set in
.
2N
®
Lift8
If the control centre is equipped with the
application, you
2N Communicator
®
can configure automatic sending of DTMF 1 after call pick-up.
The call is time limited (press button 4 upon warning announcement “Caution,
the call is ending” to extend the call).
You are recommended to end the by pressing 5 or #.
Control Room-to-Lift Calling
The control centre can also call back to the communicator. The
automatically
CU
receives every incoming call, identifies itself and, via a voice menu (DISA), offers you
another function to get through to the required audio unit. Incoming calls are time
limited as outgoing calls and are processed in the same way (extension, termination).
Summary of Contents for Lift8
