2N TELEKOMUNIKACE a.s., www.2n.cz
53/377
Figure: Mounting Hole Dimensions for Audio Unit – COP
To mount the audio unit, you need 4 electrically spot welded
or
screws, a
M3
M4
sufficiently perforated speaker area and a microphone hole. In emergency, you can fix
the audio unit on a perfectly degreased surface with a high-quality double-sided foam
self-adhesive tape.
Safety
Leave no gap between the lift control panel and the audio unit surface
to avoid acoustic speaker fault and acoustic speaker-microphone
feedback.
Do not use this type of audio unit in a position other than mounted on a
sufficiently large board. The acoustic properties of an uninstalled audio
unit cannot be guaranteed.
Separate Microphone Mounting
If the microphone is supplied separately with a cable on a 25 x 25 mm large board
with self-adhesive foil, just glue it directly behind any hole in the panel (one hole must
have the minimum diameter of 5 mm, a group of smaller holes must have the same
total area). Be sure to degrease and clean the surface carefully before!
Summary of Contents for Lift8
