2N TELEKOMUNIKACE a.s., www.2n.cz
84/377
Put the audio unit on the holes, apply the serrated lock washers from the outside
and screw the M4 nuts (both included in the delivery).
This type of mounting is suitable for lift cabin wall thickness of up to 20 mm.
If you cannot access the cabin wall from the outside, use the screws under the
pictogram glass:
Insert the hex key wrench (included in the package) in the hole on the product
bottom edge and turn it left (about 10 times) until it puts up resistance.
The window slides down by itself or with little assistance, showing its upper
brim.
Tilt the window forwards and remove it.
Now you have access to two holes in the window corners. Put
on the
2N Lift8
®
pre-drilled lift cabin wall holes and fit it with the included screws, which are
suitable for plywood, chipboard, laminated plastic etc. walls. For other materials,
use appropriate screws or M4 screws in the pre-drilled M4 threaded holes.
Replace the window and insert the hex key wrench in the bottom edge hole
turning it right about 10 times until the window slides under the panel edge.
Tighten the window applying a moderate force.
Summary of Contents for Lift8
