2N SELEA iZero, User Manual

4 / 51

www.selea.com

•  During the installation make sure to handle the product with care, avoiding collision with nearby 

objects.

•  During the installation the operator must wear all the necessary personal protective equipment 

as provided for by local legislation. If working in a construction site, it must be ensured that the 

operator is made aware of all the safety requirements by the appropriate safety personnel.

•  When connecting the product to the electricity network, make sure that all the safety measures 

are implemented, or seek the assistance of a qualified electrician.

•  We recommend the application of appropriate safety measures to reduce the risk of electric shock 

and lightning strikes. Carefully read all the instructions in this document.

•  Place or install the product on a stable base and in a protected area, so that it is not possible to 

step on or trip over power cables, LAN cables or any other connection to the camera.

•  It is recommended that an easily accessible disconnector switch is installed upstream the camera, 

in accordance with the legislation in force in the country of installation. This disconnector 

switch must have contact separation for all the poles, to ensure complete disconnection in case 

of overvoltage. Correct connection to the earth is also a mandatory requirement. Under no 

circumstances should the earth cable be interrupted by the safety switch.

•  For the connection to the power supply, use a double insulation flexible bipolar cable + earth, 

type H 05 VV-F, with a minimum section of 0.75 mm

2

.

•  Product for outdoor installations. Comply with the temperature range indicated in the manual. 

Do not touch the ends of connectors and mains cables. All damaged or worn cables must be 

replaced. In case of product malfunction, to resolve the problem, contact exclusively qualified 

personnel

•  Do not install the product during a storm, in high humidity conditions, or when wet.
•  Do not touch the ends of connectors and mains cables. All damaged or worn cables must be 

replaced immediately.

•  The cables used to connect the camera must not consists of several joined cut lengths, but rather 

only one single length going from the product to the electric cabinet.

•  Never remove the camera optical assembly.
•  Before carrying out any maintenance or cleaning activities, disconnect the electric power supply.
•  During cleaning activities only use a damp cloth. Do not use solvents or abrasives that could 

damage surfaces or components.

•  If planning not to use the camera for an extended period of time, switch off the general power 

supply switch upstream the same.

Warning!

 The laboratory tests for the definition of the retinal risk level completed on the 

beam, carried out in compliance with IEC62471:2006 1st. Ed. and EN62471:2008, 

show that 

the beam can be classed as belonging to the NO HAZARD Group

. It is however 

recommended to avoid looking directly at the illuminator when on. Exposure to infrared 

rays could cause serious eye damage, particularly for people wearing glasses.

The company rejects all responsibility for any direct or indirect damage to people, pets 

or property due to failure to follow all the instructions of this manual, particularly in connection 

with installation, use and maintenance precautions.