2N TELEKOMUNIKACE a.s., www.2n.cz
46/143
Apply the
to modify the number to be called to the GSM
Table of replaced prefixes
/UMTS network. Every modification is displayed in the
format
"prefix"/"replace with"
(99/+420, e.g.). The
must always contain one record at
Table of replaced prefixes
least or the
record if no prefix modification is made. The digits removed from
"/"
/added to the number in the
are not included in the
Table of replaced prefixes
Count
. The table is searched from top to bottom starting with the first match.
of digits
GSM network ID is an optional parameter, which is assigned to each LCR record to
make the LCR search more convenient. If this parameter is not completed, the list
number is only used for identification (1–8).
Poznámka
Count of digits defines the minimum count of digits to be dialled. Hence,
a call is successful if the count of the called number digits is equal to or
higher than the value set in the
.
Count of digits
The
does not include the digits removed from/added to
Count of digits
the number in the Table of replaced prefixes.
The
set in the Table of accepted prefixes has a higher
Count of digits
priority than the
.
Default count of digits
The
must always contain one record at least
Table of replaced prefixes
or the
record if no prefix modification is made.
"/"
Make sure that the apriopriate provider's SIM card is inserted in the GSM gateway.
Assign the incoming and outgoing groups in the Gateway configuration
GSM groups
/
menu.
assignment
For a call setup, the LCR table is searched sequentially from top to bottom. Each LCR
table row is assigned a
in which the prefix match is searched for. If a match is
Prefixlist
found, the call will be routed according to the routing group parameters (
in
Groups
the LCR table) as set in the
table. The
Gateway configuration
GSM outgoing groups
/
call will be connected via the GSM module as assigned to the
in
GSM outgoing groups
the
table.
GSM groups assignment
If the selected GSM/UMTS module is busy, the call is routed according to the next
routing rule included in the
and defined by the
table.
Groups
GSM outgoing groups
Again, the
is assigned to a GSM module in the
GSM outgoing group
GSM groups
table.
assignment
The LCR row is checked in this way until a free GSM/UMTS module is found. If no
available GSM/UMTS module (
) is found, the call is rejected.
GSM outgoing groups
