Funk-Electronic Piciorgros GmbH
DVI-100 User Guide
V1.01 page 1
1
of 2
4
3.3
Configure the available TETRA groups
The DVI-100 manages up to 25 TETRA groups. Each group must be configured in the
infrastructure. The DVI-100 can register to these groups and they have to be
programmed at “TETRA >> Group configuration”.
To configure the "selected" group, the corresponding number must be written to the
upper input field. All other groups are "scanned".
In DMO mode, each group includes also a frequency input field. As there will be no
scanned groups in DMO mode, only the selected group is active in this case, using the
configured frequency. A change between DMO groups (and frequencies) can be
achieved by changing the selected group of the DVI-100.
Group X name
This is the name of the group. It is an additional information which is transmitted to the
clients to display group names. It has no effect to the TETRA network.
GSSI
The Group Short Subscriber Identity (GSSI) is the identifier of the TETRA group.
DMO Frequency (DMO mode only)
This field is only visible in DMO mode and defines the frequency on which the DVI-
100 is operating for any given groups. In DMO mode, there are no scanned groups and
the DVI-100 will only operate on the selected group. With changing the selected group,
also the frequency will be changed according to the configuration of this page.
