34
2.
The D-Link Air DWL-650 Configuration
screen appears.
3.
Select the Configuration tab.
4.
In the Mode field, enter
Infrastructure
.
5.
In the SSID field, enter the word “
2WIRE
”
followed by the last three digits of your
HomePortal serial number. This is the Wireless
Network Name. The Wireless Network Name is
case-sensitive, so it is important that you enter
the word “
2WIRE
” in capital letters.
6.
In the Tx Rate pull-down menu, verify that
Fully Automatic
is selected (this is the default).
7.
In the PS Mode pull-down menu, verify that
Disabled
is selected (this is the default).
8.
Click
Apply Changes
.
9.
Select the Encryption tab.
10.
From the Encryption (WEP) pull-down menu,
select
64 Bit
.
11.
In the WEP Key Entry field, select the
Manual
Entry
radio button.
12.
In the Key 1 field, enter your ten-digit Wireless
Encryption Key, located on the bottom of your
HomePortal.
13.
From the Default Tx Key pull-down, select
1
.
14.
Click
Apply
.
15.
Click
OK
.
