Connect the First Computer to the Gateway
4
Ethernet Connection
Figure 1. Gateway Connected Via Ethernet
1.
Connect the provided power adapter from the gateway’s
POWER
port to an electrical outlet. The
POWER
light on the front of the gateway should be green.
2.
Connect the provided gray phone cable from the gateway’s
PHONE LINE
port to the DSL filter jack labeled
DSL/HPNA
.
3.
Connect the
yellow Ethernet cable
provided with the gateway from any available
LOCAL
ETHERNET
port on
the gateway to your computer’s Ethernet port.
Check Your Connections
With your computer completely started, verify the
POWER
and
ETHERNET
indicator lights on the front of the
2Wire gateway are green. If they are not, see “Understanding the Indicator Lights” on page 18.
The
INTERNET
indicator light will not turn green until the gateway software has been installed and an Internet
connection has been established.
DSL
PHONE LINES
PO
W
ER
RESET
Gateway
2Wire
DSL filter
AC power
Telephone wall jack
with DSL
Computer
DRAFT ONLY
2Wire Confidential