Connect the First Computer to the Gateway
5
Wireless Connection
Requires wireless-enabled notebook or a computer with an 802.11b/g wireless network adapter installed.
Wireless adapters can be purchased from your service provider.
Figure 2. Gateway Connected Via Wireless
1.
Connect the provided AC power adapter from the 2Wire gateway’s
POWER
port to an electrical outlet.
The
POWER
light on the front of the gateway should be green.
2.
Connect the provided gray telephone cable from the gateway’s
PHONE LINE
port to a telephone jack with
DSL service.
3.
Install your wireless adapter according to the manufacturer’s instructions (see note below).
Note:
If you use a 2Wire wireless adapter (PCI, PC card, or USB adapter) for wireless
networking, the 2Wire CD automatically configures it to communicate with the gateway
during setup. If you are
NOT
using a 2Wire wireless adapter, you must manually configure
your adapter to communicate with the gateway using the information on page 6.
DSL
PHONE LINES
PO
W
ER
RESET
2
AC power
2Wire
DSL filter
Telephone wall jack
with DSL
Computer
(with 802.11g wireless
adapter installed)
Gateway 2701
DRAFT ONLY
2Wire Confidential