Connect the First Computer to the Gateway
6
Non-2Wire Wireless Adapter Configuration
Locating the Serial Number and Wireless
Encryption Key
The serial number of your 2Wire gateway is used as the network name (SSID). Beneath the serial number is
a ten-digit number which is used as the encryption key. These are located on the bottom of your gateway
(shown in vertical orientation). You will need this information to configure your wireless adapter.
Configuring the Adapter
1.
Install and configure your wireless adapter according to the manufacturer’s instructions.
2.
Use the network adapter configuration software or Windows network connection wizard to set the
network name (SSID) and encryption key (WEP).
a.
The network name is the word “2WIRE” (in all capital letters), followed by the last three digits of the
gateway serial number (for example, 2WIRE110).
b.
The encryption key is a 64-bit hex value, located beneath the bar code on the bottom of the 2Wire
gateway. In the example, it is 4119627022.
c.
For Mac OS X users, you may need to enter the “$” character at the beginning of the encryption key
(for example, $4119627022).
POWER
DSL
INTERNET
PHONE 1
2701HGV
PHONE 2
ETHERNET
WIRELESS
2701HGV
SN: 145511100110
2Wire
®
Gateway
www.2Wire.com
Complies with Part 68, FCC Rules
FCC Reg: 66KRDL01BTW2701
REN=0.1
FLX
[ 4119627022 ]
Assembly Number 4200-000428-000
Tested To Comply With
FCC Standards
FCC ID: PGR2W2701
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
Concentrador Inalambrico
para Red (ADSL)
Marca: 2Wire
Modelo: RG2701HGV-00
Made in Malaysia
Patent No. Des. 437,289
5,1V 3A
RG2701HGV-00
USB-PC
DRAFT ONLY
2Wire Confidential
