110
Diagnosing connection problems
This section describes some connection problems you may encounter with your Intelligent Gateway
network and provides suggestions for solving those problems. If the problem you are having is not covered
here or in the Help system, or if the suggestions provided do not solve the problem, call the Technical
Support number provided with your Intelligent Gateway.
POWER
indicator light is not lit
If the
POWER
indicator light is not lit, the Intelligent Gateway is not getting power:
1.
Check to see if the power cable is plugged into the power outlet.
2.
Make sure the power cord is correctly and securely connected into the Intelligent Gateway.
Note:
If the
POWER
indicator light is red (signifying a system error), or does not light after performing
the steps above, contact BT Openworld Customer Care.
BROADBAND LINK
indicator light is red
If the
BROADBAND LINK
indicator light is red, the Intelligent Gateway has not established a connection to
your DSL service provider:
1.
Verify that a telephone cord is plugged into the
PHONE
LINE
port on the Intelligent Gateway and into
the
telephone socket with DSL service
.
2.
Verify that DSL service is activated by calling your DSL service provider.
LOCAL NETWORK
indicator light is not lit
If your networked computers are powered on and the
LOCAL NETWORK
indicator light is not lit, the
Intelligent Gateway may not have been connected correctly. Double check the connection diagrams for
your particular connection type against your completed Intelligent Gateway setup.