| Vinyl Blinds
2
Valance Corners
Valance Returns
Spacers
L-Bracket
Valance Clips
Plastic Corner
Wing Nut and Bolt
OPTIONAL HARDWARE
Hold Down Brackets
with Screws
• Facing the window, hold the end bracket marked “LH” in the
upper left hand corner of the window against the top and
side of the window casing.
INSIDE MOUNT
• Flush with the front of the
window casing if you are
mounting your blind in a
window with the minimum
depth.
NOTE: Be sure to check for any obstructions such as window
cranks or which may require different bracket locations.
• Mark the window casing
through the holes in either
the side or top of the end
bracket. For maximum
stability, the marks should
be made diagonally.
• Using a drill with a
1
/
16
" drill
bit or an awl, make a small
pilot hole at each mark.
• Using a flathead
screwdriver, open the
latches of the end
brackets.
• Mount the bracket
using two of the screws
provided.
• Repeat this procedure for
the right end bracket.
• Position the front edge of the closed bracket:
3
/
4
"
•
3
/
4
" back to have the
valance flush with the
front of the window
casing.
