Predator ULTRA Installation Manual V2.1.25.3
Page 64
© 360 Vision Technology Ltd.
12 Network Settings Recovery
When network settings are changed, the IP address, Net Mask and Gateway are validated before they are
saved. However if the settings are such that the Thermal IP has settings which mean that it cannot be seen
on the user’s network, it may become necessary to use the ‘Network Settings Recovery’ feature as described
below.
The ‘Network Settings Recovery’ IP address may conflict with an IP address that is already defined on the
network, it may be necessary to disconnect the Thermal IP from the network and control it locally using a
network connection to a laptop so that the IP address can be set to a suitable setting before the Thermal IP is
reconnected to the main network.
Procedure for ‘Network Settings Recovery’
Disconnect the Thermal IP from the network, until process is complete.
Turn power to the Thermal IP OFF for 3 seconds.
Turn power to the Thermal IP ON for approx. 1 minute.
Repeat the above three times.
On the final power ON, leave the power switched on for at least 5 minutes to allow the Thermal IP to initialise.
(See section Locating the Thermal IP on your network - page 26).
