5
Exception:
If the software for the CCD linear
camera (1013311) is already installed on your
computer, carry out the following instructions:
•
Connect 3B NET
log
™ to the computer via
the USB cable.
The computer
will not
report that a new hard-
ware
has been detected
.
•
Insert the installation CD into the CD-ROM
drive of the computer.
Windows XP:
•
System control panel -> System -> Hard-
ware ->
open
Device manager
.
•
Double-click on USB controller.
•
Double-click “ULICE USB Product”.
•
Click
Driver -> Update driver
. (The hard-
ware assistant will start.)
•
Do not activate Windows Update.
•
Select “Install software from specific
source”.
•
Select “Do not search. Autodetect driver”.
•
Select “Drive” and then “Search” to estab-
lish the path to the driver.
•
Click “Yes” to confirm that the file should
be overwritten.
•
Click “Proceed with installation” when the
hardware message states that the software
has failed to pass the Windows Logo Test.
Windows 7 and 8.1:
•
Open the hardware manager under
Control
Panel -> Hardware and Sound -> Hard-
ware Manager
.
•
Double click "USB Controller" in the hard-
ware manager.
•
Double click “ULICE USB Product”.
•
Click
Drivers -> Update Driver
.
•
A small window will open so that you can
search for the driver software. Click "
Find
driver software on this computer"
in the
window.
•
Click "
Select from a list of device drivers on
this computer"
.
•
Click the "
Medium…"
button.
•
Click the "
Browse…"
button and select the
path for the driver.
•
Click “Yes” to confirm that the file should
be overwritten.
7.2 Software installation
Note on installing the software
For this software, please refer to the installa-
tion instructions available in the 3B NET
lab
™
software manual.
8. Operating without a computer
Operating a 3B NET
log
™ device without a
computer is achieved by using the buttons on
the operating panel. The functions of these
buttons may change according to the operation
being undertaken.
Note:
a menu selection can be can-
celled at any time by using the
Channel
←
button.
8.1 Battery level and temperature display
•
Switch on the 3B NET
log
™ device by
pressing the
On/Off
button.
•
Press the
Date/Time
↵
button.
The following should appear on the display:
e.g.:
BATTERY: 100%
TEMP.: 22.0°C
8.2 Setting the time
•
Switch on the 3B NET
log
™ device by
pressing the
On/Off
button.
•
Press the
Date/Time
↵
button twice (the
time field will appear on the display).
•
Press the
Store
↓
button (the input field for
SET TIME will appear on the display).
•
Specify the desired time in the input field
by pressing the
Rate
↑
or the
Store
↓
but-
ton and use the
Channel
←
button to skip
between the hours, minutes and seconds
fields.
•
Confirm by pressing the
Date/Time
↵
but-
ton.
8.3 Setting the date
•
Switch on the 3B NET
log
™ device by
pressing the
On/Off
button.
•
Press the
Date/Time
↵
three times (the
date field will appear on the display).
•
Press the
Store
↓
button (the input field for
SET DATE will appear on the display).
•
Specify the desired date in the input field
by pressing the
Rate
↑
or
Store
↓
button
and use the
Channel
←
button to skip be-
tween the year, month and day fields.
Summary of Contents for 3B Netlog 1000009
Page 12: ......