7
•
Turn off the 3B NET
log™
device and un-
plug the Ethernet cable.
•
Press down the
Store
↓
button and turn on
the 3B NET
log™
. The display should show
the following:
•
Confirm this by pressing the
Date/Time
↵
button. The following will then appear on
the display:
•
Now plug in the Ethernet cable to connect
the 3B NET
log
™ unit to the local network.
Confirm the above question by pressing
Date/Time
↵
.
An available IP address for the local network
will be sought out and assigned to the device:
After about 3 seconds, the IP address, the
subnet mask and the gateway address will be
displayed. The display might, for example,
display the following:
•
Use the
Date/Time
↵
button to confirm.
The 3B NET
log
™ unit will then have the IP
address assigned to it.
9.2 Assignment of a known or fixed IP ad-
dress
•
Turn off the 3B NET
log™
device and un-
plug the Ethernet cable.
•
Press down the
Store
↓
button and turn on
the 3B NET
log™
. The display should show
the following:
•
Press the
Rate
↑
or
Store
↓
button until the
display shows the following:
•
Use the
Date/Time
↵
button to confirm this,
then plug in the Ethernet cable to connect
the 3B NETlog™ unit to the local network.
•
Now you can modify the known, fixed IP
address by pressing the
Store
↓
or
Rate
↑
buttons along with
Channel
←
or
Date/Time
↵
e.g.:
•
Confirm the address by pressing the
Date/Time
↵
button. Now enter or modify
the subnet mask, e.g.:
•
Confirm the mask by pressing the
Date/Time
↵
button. Now enter or modify
the gateway address, e.g.:
•
Confirm using the
Date/Time
↵
button.
9.3 Assignment of default value for IP ad-
dress
•
Turn off the 3B NET
log™
device and un-
plug the Ethernet cable.
•
Remove a battery from the unit.
•
Pressing down the
Rate
↑
a
nd
Date/Time
↵
buttons at the same time, put
the battery back in the unit.
9.4 Turning off Ethernet mode
•
Turn off the 3B NET
log™
device and un-
plug the Ethernet cable.
•
Press down the
Store
↓
button and turn on
the 3B NET
log™
. The display should show
the following:
•
Press the
Rate
↑
or
Store
↓
button until the
display appears as follows:
•
Confirm by pressing the
Date/Time
↵
but-
ton. Ethernet mode is now switched off.
The full menu for configuring Ethernet can be
found in the appendix.
Summary of Contents for 3B Netlog 1000009
Page 12: ......