4-8
C
HAPTER
4: S
TANDARD
I
NSTALLATION
AND
C
ONFIGURATION
If you want to use the same settings on other adapters, you
can save the configuration settings to a file. Select <Save>
under the <File Options> command button in the Adapter
Configuration dialog box. Enter a filename, for example:
3CTOK.SET
Select a directory using the arrow keys and press [Enter]. This
saves the settings to the default file 3CTOK.SET in the directory
you selected. Refer to the on-line help (by pressing [F1]) for
more information.
Changing Settings for Multiple Adapters
To change the settings for multiple adapters, return to the
main window of the Configuration and Diagnostic Program,
press [F10], and select the next adapter to configure. Repeat
steps 8 through 13 for each adapter. Select each adapter as it
needs to be configured.
When all adapters have been set to the desired settings,
proceed to Chapter 5, “Installing Network Drivers.”
Video Conflicts with BIOS/MMIO and Shared RAM Addresses
Many PC video cards use the memory range from C0000 to
C7FFF. The
TokenDisk
diskette configuration program supports
settings within this same memory range for the BIOS/MMIO
and Shared RAM address parameters. The configuration
program identifies a conflict on most PCs, but will then allow
this configuration to be saved.
If you save such a configuration despite a conflict with the video
card, the PC will not operate until the adapter is removed. The
adapter must then be reconfigured in a PC without the
conflicting setting or must be returned to 3Com for reset.
3Com therefore strongly recommends using settings other
than C0000, C2000, C4000, or C6000 for the ROM and
Shared RAM addresses.
