C
E
RROR
M
ESSAGES
This appendix contains an alphabetical list of the error messages
that may appear when you use the
TokenDisk
diskette
Configuration and Diagnostic Program for the 3C619C adapter.
For information about running the adapter’s diagnostic
program, refer to Chapter 7, “Troubleshooting,” and to
Appendix A, “Using the Configuration and Diagnostic Program.”
Messages
A diagnostic test name was found in the configuration file at
line xxxx. Only configuration parameter variables are allowed.
See the INSTRUCT.TXT file in the \DIAG subdirectory of this
diskette for a description of the file format.
A lobe cable must be connected from the selected adapter
to a retiming concentrator or MAU. The Open Adapter for
Ring Operation Test and Adapter Wrap Test both take more
than 30 seconds to complete their tasks.
A syntax error was found in the configuration file at line xxxx.
The configuration file format is described in the
INSTRUCT.TXT file in the \DIAG subdirectory of this diskette.
Adapter failed while trying to read the adapter configuration
stored on the adapter. Save a new configuration to the adapter.
If the problem persists, swap with a known good 3C619C and
try again.
An adapter was configured for EISA mode, but the EISA
configuration utility has not run yet. Exit this program, place
your EISA configuration diskette in drive A, and reboot the PC.
