6
R
ELEASE
N
OTES
S
UPER
S
TACK
® II R
EMOTE
A
CCESS
S
YSTEM
1500 R
ELEASE
2.0
Table 1
Event Viewer Messages
Extra Blank Faceplate
Packed with the PAU
For this release of the software, an I/O card does not have to be present in
the Router Unit (however, if one is installed it must be installed in
rm0/slot:1). Although you do not have to install an I/O card in the Router
Unit, it is recommended that you cover the blank slot so that no slots are
left exposed. An extra face plate is provided when you purchase a PAU.
This face plate should be used to cover this empty slot in your Router
Unit. It can be easily attached to the unit by using the panel screws that
are provided.
PAU Delete Command
Remove the STACKNET cable from the PAU before issuing a delete
command.
set imodem interface
command in the CLI
for the PAU
There is an undocumented
set imodem interface
command for saving
modem configurations on the PAU that is not displayed in the section
entitled, “
Set Commands
” in Chapter 4 of the
SuperStack
®
II Remote
Access System 1500 System Reference Guide
. Enter the following
command to save your PAU modem configuration:
set imodem interface <PAU interface name> at at&S
Restoring Router Unit
to Factory Defaults
When the Router Unit is restored to factory defaults, the IP address and
manage user(s) will be deleted. To begin using your RAS 1500, you must
reassign an IP address, either through the IP Wizard available from the 2.0
Resource CD if you are a PC user, or through the CLI Quick Setup if you
are a UNIX user. Refer to the
SuperStack
®
II
Remote Access System 1500
Quick Setup Guide
for details on setting an IP address for your RAS 1500.
Message ID
Message
1
Security Service installed successfully
2
Security Service disabled
3
Security Service enabled successfully
with encryption key
(key)
4
Security Service stopped
5
User successfully authenticated
user
RAS 1500
IP Address
6
User failed to authenticate
user
RAS 1500
IP Address
