Viewing and Configuring System Information
113
5
Restore all files by entering:
mput*
6
Exit FTP by entering:
bye
7
Telnet to the node.
8
Select
[1] System Administration
to display the System Administration menu.
9
Select
[12] Update Flash File System.
10
Select
[Y]
from the confirmation prompt to update the flash file system.
Wait for the
Update Completed
message before continuing to Step 11.
11
Select
[10] Reset Interface Card
to display the Reset Port Card screen.
12
Enter [1], for the MCPU card.
13
Enter
[Y]
from the confirmation prompt to reset the card.
14
Repeat steps 11-13 for each card in the shelf.
You must have read/write access on the node to perform the restore operation.
Backing up the Code Image
To back up the code image, follow these steps:
1
FTP <node>.
n
FTP login will be the node name (upper left hand corner of user interface).
n
FTP password will be the node password (the password used to access user
interface).
2
Switch to binary mode by entering:
binary
3
Change directory to /fileDev/main by entering:
cd /fileDev/main
4
Change directory to /flashDev/main (type “cd /flashDev/main”).
5
Get file image by entering:
get image bootmgmt.abs
Conversion of file image to bootmgmt.abs is not necessary, but is done to make
the restore seem the same as a code download, which it.
6
Exit FTP by entering:
bye
Restoring the Code Image
To restore the code image, follow these steps:
1
Move to directory that contains the bootmgmt.abs file.
2
FTP <node>.
n
FTP login will be the node name (upper left hand corner of user interface).
n
FTP password will be the node password (the password used to access user
interface).
Summary of Contents for 3C63100-AC-C - PathBuilder S600...
