Configuring the DS1 (or E1) UNI with IMA Modules
133
Figure 94
Add Group Menu (Selecting Group Type)
5
Enter
[1] UNI
. The Add Group menu appears as shown in Figure 95.
Figure 95
Add Group Menu (Adding UNI Group)
6
Select
[1] Set Admin. Port(s)
. The following prompt appears at the bottom of the
screen:
Enter Admin Port(s) (1..4):
7
Enter the port number of the T1/E1 port you want to include in the UNI group.
8
Select
[2] Set Admin. Status
and enter
[2]
to put the group in service.
9
Select
[3] Set Number of VPI for VCC
and specify the number of distinct VPIs that
can be used for VCCs on this card:
1-256
. The remaining VPIs are available for
VPCs.
10
Select
[3]
Previous Menu.
11
If desired, repeat steps 5-8 to set up a additional UNI groups and put them into
service.
Summary of Contents for 3C63100-AC-C - PathBuilder S600...
