Configuring the DS1 (or E1) UNI with IMA Modules
137
5
Change any of the group parameters as desired. For parameter definitions, see
“Adding IMA Groups” earlier in this chapter.
Configuring Virtual Interfaces for IMA Groups
To configure virtual interfaces for IMA groups, follow these steps:
1
From the Group menu, shown earlier in Figure 93, select
[1] List/Modify Group
to
open the List/Modify Group Selection menu, shown earlier in Figure 97.
2
Enter the number corresponding to the group for which you want to configure
virtual interfaces to display the Group Configuration Options menu for that group.
3
From the Group Configuration Options menu, shown earlier in Figure 98, select
[2] Virtual Interfaces
to open the Virtual Interface Configuration menu. This menu
is the same as the MCPU Virtual Interfaces Configuration menu, shown earlier in
Figure 83.
4
Configure virtual interfaces as described under “Configuring Virtual Interfaces”
earlier in this chapter. You configure virtual interfaces for IMA groups in the same
way that you configure virtual interfaces for the MCPU card, except that you can
configure 24 VIs total for each IMA group, as opposed to 2 for the MCPU card.
Deleting IMA and UNI
Groups
To delete an existing IMA or UNI group, follow these steps:
1
From the List Card menu, shown earlier in Figure 80, select the number
corresponding to the slot in which the DS1 UNI or E1 UNI card is installed to
display the DS1 UNI or E1 UNI. Configuration menu, shown earlier in Figure 90.
2
Select
[3] Group Configuration
to display the Group menu, shown earlier in
Figure 93.
3
From the Group menu, select
[3] Delete Group
. The Delete Group Selection menu
appears.
4
Enter the number corresponding to the group you want to delete.
5
Enter
[Y]
in response to the confirmation prompt to delete the group.
When you delete an IMA group, all the VCs using that group are also deleted.
Viewing IMA Link Status
To view IMA Link Status for a selected DS1 or E1 port, follow these steps:
1
From the List Card menu, shown earlier in Figure 80, select the number
corresponding to the slot in which the DS1 UNI or E1 UNI card is installed to open
the UNI Configuration menu, shown earlier in Figure 90.
2
Select
[2] IMA Link Status
to open the IMA Link Status Selection menu, shown in
Figure 100. The IMA Link Status Selection menu lists only the ports that are
members of an IMA group.
Summary of Contents for 3C63100-AC-C - PathBuilder S600...
